Swastik Fire Protection

Features :

• Most Sophisticated "Detector Intelligence" available today .
• Multi-Criteria fire detection for the price of a photoelectric detector
• FirePrint™ Technology to discriminate between deceptive phenomena and an actual fire .
• Easily programmed to match specific hazard profiles from the control panel .
• Polarity Insensitive with SureWire™ Technology
• Pre-Alarm reporting based on fire profile selected
• Remote sensitivity measurement capability • System logic activation based on any of three inputs from detector (smoke, heat or neural network) .
• Detectors are self-testing, completing diagnostics every 4 seconds
• Field cleanable chamber with replaceable chamber parts available
• Multi-color detector status LED .
• Two-wire operation .
• Compatible Model DPU field device programmer/tester unit .
• Supports software based automatic environmental compensation .
• Optional fully programmable relay base, audible base, and duct housing .
• ULC Listed, CSFM, FM, NYMEA Ap .

Features:

• Automatically adjusts sensitivity levels without operator intervention or programming. Sensitivity increases with heat.
• Microprocessor-based, combination photo and thermal technology.
• FlashScan and CLIP compatible.
• Sleek, low-profile design.
• Addressing by switch.
• Dual bi-color LED design provides 360° viewing angle.
• LEDs lock red when in alarm. In FlashScan, LEDs flash green in standby for normal condition.
• Built-in tamper-resistant feature.
• Sealed against back pressure.
• Several base options, including relay, isolator, and sounder.
• Built-in functional test switch activated by external magnet.
• Capable of heat-only alarm mode, enabled by a special command from the panel.

Features

SLC Loop:
• Two-wire SLC loop connection
• Unit uses base for wiring
• Compatible with FlashScan® and CLIP protocol systems
• Stable communication technique with noise immunit

Addressing:
• Addressable by device
• Rotary, decimal addressing(Refer to the NOTIFIER panel manuals for device capacity.)

Architecture:
• Sleek, low-profile, stylish design• Unique single-source design to respond quickly and dependablyto a broad range of fires
• Integral communications and built-in device-type identification
• Built-in tamper resistant feature
• Remote test feature from the panel
• Walk test with address display (an address on 121 will blink thedetector LED: 12-[pause]-1(FlashScan systems only)
• Built-in functional test switch activated by external magnet
• Removable cover and insect-resistant screen for simple fieldcleaning
• Expanded color optionsOPERATION:
• Designed to meet UL 268 7th Edition
• Factory preset at 1.5% nominal sensitivity for panel alarm threshold level
• LED “blinks” when the unit is polled (communicating with the firepanel) and latches in alarm.
• Low standby current

Mechanicals:
• Sealed against back pressure
• SEMS screws for wiring of the separate base
• Designed for direct-surface or electrical-box mounting
• Plugs into separate base for ease of installation and maintenance

Features ! Integral microprocessor ! Non-volatile memory ! Automatic mapping device ! Electronic addressing ! Environmental compensation ! Intelligent detector ! Wide 0.67% to 3.77%/ft. sensitivity range ! Twenty pre-alarm sensitivity values, set in 5% increments¹ ! Identification of dirty or defective detectors ! Automatic day/night sensitivity adjustment ! Twin RED/GREEN status LEDs ! Standard, relay, fault isolator, and audible mounting bases ! Designed and manufactured to ISO 9001 standards